Basic CTS pot to replace the X, Y or Z pot in the Cougar. Pots are different, please mention which one you need.

These pots are the same brand as used in your Cougar and as such will suffer from the same problem!
CW offer the pot presoldered to the 3 wires and crimped on the other end to a 3 contacts connector that will snap into the receiver on your PCB.
No soldering required - drop in replacement.

See install instructions

Same part as in your Cougar.
TM ships the microstick assembly only through their sales system.
CW sends you the the Microstick already soldered on the small PCB with it's 6pin connector.
As a consequence, you won't need to unsolder your bad microstick from it's PCB to solder the new one on.

No soldering required - drop in replacement.

The plates are made of 1mm width aluminium printed in black serigraphy. The plate is 130 x 45 x 1 mm which is the same as the original golded cougar plate.
I can engrave the serial numbers myself with a letter punch kit or leave the area blank and you do your own engraving. Just let me know when you place your order.

This parts replace the center cables connecting the Cougar stick base PCB to the Cougar stick handle PCB. Both connectors are included.
Installation is quite straightforward but requires opening both the base and the handle.
It is also an ideal part for homemade modification between the stick and the Cougar base.

Contact me for order

Double pot + button to replace the Range (Rng) pot in the Cougar throttle.

These pots are the same brand as used in your Cougar
soldering required

Simple pot with center detent to replace the Antenna (Ant) pot in the Cougar throttle.

These pots are the same brand as used in your Cougar
soldering required